 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| NSVS735 Dec-01 JRC SAW FILTER NSVS735 Application AMPS RX + PCS(USA) RX Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Input and Output Impedance Nominal Center Frequency (f0) Insertion Loss 869~894MHz 1930~1990MHz Response Variation 869~894MHz 1930~1990MHz Input and Output VSWR 869~894MHz 1930~1990MHz Out of Band Rejection 824~849MHz (Relative to DC~1850MHz Through Level) 1850~1910MHz 3860~3980MHz 5000~5500MHz Maximum Rating: (Table 2) Table 2. Maximum Ratings Item Maximum Input Power Maximum DC Voltage Operating Temperature Range Storage Temperature AMPS RX Spec. Typical 3.5dB max. 2.0dB max. 2.5 max. 35dB min. 50 881.5MHz 3.0dB 1.3dB 2.0 43dB - PCS(USA) RX Spec. Typical 4.0dB max. 2.5dB max. 2.5 max. 20dB min. 8dB min. 13dB min. 5dB min. 50 1960MHz 3.0dB 2.0dB 2.0 25dB 15dB 17dB 8dB (Operating Temperature Range: -30~+85C) Rating +20dBm 7.5V -30~+85C -40~+95C Mechanical Specifications: (Fig.2) Package is designed as small as 3.0x3.0x1.15[mm3] for SMD (Surface Mount Device) type. Notice: This part is electrostatic discharge sensitive and may be damaged by improper handling. Communications Equipment Division Communications Equipment Marketing Department 17-22 Akasaka 2-chome minato-ku, Tokyo. 107-0052 Japan Tel. +81 3-3584-8811 Fax. +81 3-3584-8876 http://www.jrc.co.jp/product/comm/deveice/saw/saw_top.html (Japanese) http://www.jrc.co.jp/product/comm/device/saw/saw_top_e.html (English) NSVS735 Dec-01 IN 50 1 8 7 5 IN 50 2 SAW 6 3 4 OUT 50 OUT 50 Fig.1 Measuring circuit (1) 3.00.15 3.0 0.15 JDR (a) 17 (2) (3) (b) 4 3 5 (0 .6 ) Marking (1) Manufacture's Mark (2) Lot Number (a) Year (b) Month *Oct.--- X Nov.--- Y Dec.--- Z (3) Part number Mark Pin no. 1 2 3 4 5 6 7 8 Connection IN1(881.5MHz) GND IN2(1960MHz) GND OUT2(1960MHz) GND OUT1(881.5MHz) GND 1 .1 5 0 .1 5 1 8 (0.75) [6x] (1 .2) 7 (0 .53) [4x] Fig.2 Package dimensions (in mm) 1.15 3.8 0.6 1.15 3.8 0.6 0.93 Via -Hole( 0.3) 0.93 Fig.3 Desirable land area (in mm) [4 x] 2 (0 .5 5 ) 6 NSVS735 Dec-01 Notice 1. Use this component within operating temperature range. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -30C or more than +85C, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. 2. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350C max., the time of soldering: 10 seconds max., the power of soldering iron: 30W max.. 3. Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. 4. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. 5. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. 6. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. And do not transport this component with bare hand. 7. As it might be a cause of degradation or destruction to apply D.C. voltage between each terminal, apply D.C. voltage 7.5V max. in actual circuit. Note 1. This specification specifies the quality of this component as a single unit. Make sure that this component is evaluated and confirmed against this specification when it is mounted to your products. AMPS RX + PCS(USA) RX SAW FILTER NSVS735(881.5MHz) 0 S21 FREQUENCY CHARACTERISTICS 0 Insertion Loss [dB] 20 2 Insertion Loss [dB] 40 4 60 6 80 8 100 781.5 881.5 Frequency [MHz] 981.5 10 S11 S22 S11 6 5 6 5 S22 VSWR 4 3 2 1 781.5 VSWR 4 3 2 1 781.5 881.5 Frequency [MHz] 981.5 881.5 Frequency [MHz] 981.5 0 S21 InsertionLoss [dB] 20 40 60 0 1500 Frequency [MHz] 3000 Japan Radio Co.,Ltd. (1dB Scale) AMPS RX + PCS(USA) RX SAW FILTER NSVS735 (1960MHz) 0 S21 FREQUENCY CHARACTERISTICS 0 Insertion Loss [dB] 20 2 Insertion Loss [dB] 40 4 60 6 80 8 100 1710 1960 Frequency [MHz] 2210 10 S11 S22 S11 6 5 6 5 S22 VSWR 4 3 2 1 1710 VSWR 4 3 2 1 1710 1960 Frequency [MHz] 2210 1960 Frequency [MHz] 2210 0 S21 InsertionLoss [dB] 20 40 60 0 3000 Frequency [MHz] 6000 Japan Radio Co.,Ltd. (1dB Scale) |
Price & Availability of NSVS735
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |